MIL-DTL-81928C(AS)
3.1.6.2.1 Repairable assembly maintenance WPs. When the LORA/MP directs, WPs shall be
created to provide coverage for the repairable (at manual's maintenance level) assemblies that are
contained in the equipment. Repairable assembly/subassembly WPs shall contain principles of
operation, testing and troubleshooting, and maintenance instructions with IPB to the bit/piece
component. Depending on testing method, internal circuits, their relationship to each other, input
and output signals, waveforms, and time-phase relationship of waveforms shall be included. A
separate WP should be created to support each repairable assembly/subassembly. When the task
analysis requires, selected coverage may be located, as separate coverage, within the WP for the
next higher assembly (refer to Task Analysis in NAVAIR 00-25-700).
3.1.6.2.2 Foldout illustrations (multiple WP application). When a foldout schematic diagram
(functional block, signal flow, electrical or electronic diagrams, etc.) or other foldout is used by
more than one WP, placement in the last WP of a manual or in a separate manual will greatly
improve the usability of the data. A foldout illustration shall follow any related text or usage, e.g.,
description, principles of operation, testing, and troubleshooting. A foldout illustration shall also
follow related data required to be used with the foldout illustration, e.g., test point identification,
including the IPB when used for test point identification and related wire lists.
3.1.7 Multimanual coverage. (Refer to "Multivolume and Multimanual Sets" in
MIL-DTL-81927). The coverage may be provided as a combined manual or divided into a set of
manuals. This division may be required for reasons of data element usability, or if the anticipated
page count of the resultant manual requires such a division.
3.1.8 Multilevel maintenance coverage. More than one level of maintenance may be
addressed in a manual or a set of manuals. Manual division shall be by subject matter or levels of
maintenance or as specified in the contract. The maintenance procedures shall reflect the
approved MP and parts provisioning data at the appropriate maintenance level coverage. (See
3.1.5.2.)
3.1.9 General technical content.
3.1.9.1 Standard shop practices and techniques. Mandatory compliance with standard shop
practices and techniques available in general maintenance series manuals should not be included.
When applicable, appropriate reference should be made to these manuals in accordance with
MIL-DTL-81927.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business