MIL-DTL-24784/20B (SH)
e. Obvious repair actions such as soldering, use of multimeters, hand tools, and so forth, shall
not be included except where these actions involve hazards to personnel or equipment.
3.6.9.4.4 Supporting illustrations and data. The use of clear, sharp illustrations to supplement
description and maintenance coverage is required. Exploded views are required for parts location
illustration. As a minimum, illustrations or sketches of the following shall, when applicable, be
included:
a.
Typical bearings for rotating or moving equipment.
b.
Method of taking clearance measurements where required.
c.
Typical mechanism for absorbing thrust where applicable.
d.
Locking devices when applicable.
e.
Typical seal assembly (pressure and vacuum seals or controlled leakage between rotor and
casing).
f.
Typical assembly of blading to rotor, with lock devices, where applicable.
g.
Typical assembly of field poles, laminated core iron, electrical windings, commutator, slip
rings, and brush rigging where applicable.
h.
Equipment assembly with upper casing partially removed.
i.
Series of illustrations showing installation of supervisory instruments (such as RTEs in
bearings).
3.6.9.5 Section 5, Parts list. The parts list shall list and identify and shall reference or include an
illustration that will show the location of all repair parts, including the attaching hardware
required to support the maintenance concept. All mechanical parts subject to replacement,
although not provisioned as a spare part, such as handles, slides, plates, covers, and so forth
included in the Provisioning Documentation shall be included in the parts list and identified in the
respective parts-location diagram. This chapter shall include:
a.
Introduction.
b.
Parts list (including attaching hardware).
c.
List of manufacturers.
d.
Parts location illustrations.
3.6.9.5.1 Introduction. The introduction shall contain an explanation of the scope and
arrangement of the parts list. The following type of information shall be included:
a. Models of equipments and, where all equipment of a specific model do not have
interchangeable parts, serial number of equipments covered.
b. Explanation of any special notes.
c. Explanation and instructions for using the list of common item descriptions.
d. Explanation and instructions for using the list of attaching hardware.
e. Explanation and instructions for using the parts list.
f. Explanation and use of the list of manufacturers.
35
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business