MIL-DTL-24784 / 21B (SH)
3.6.2.2.4 Reference data. Reference data, equivalent to the following, shall be included in
tabular form:
a. Descriptive (identification plate data) which identifies manufacturer, type, model, part or
identifying number (PIN), Joint Electronic Type Designation (when applicable), repairable
identification code (RIC) and allowance parts list (APL), as applicable.
b. Functional characteristics, such as: power requirements, horsepower, pressure, capacity,
modes of operation, power output, frequency, pulse characteristics, sensitivity, selectivity,
including tolerances, where applicable.
c. Capabilities and limitations, such as: pounds of thrust, knots, turning radius, minimum and
maximum ranges, degree of coverage, resolution, accuracy.
d. Rated outputs, such as: wattages, voltages, horsepower, gallons per minute.
e. Environmental characteristics, such as: ambient temperatures, heat dissipation per unit,
humidity limits.
3.6.2.2.5 Equipment, accessories, and documents supplied. A tabular listing of all equipment
and documents supplied shall be included. List the equipment, its units, and its accessories
(special tools, test equipment, miscellaneous parts, and Government-furnished items) which form
a part of, or are supplied with, the equipment. The table shall include the following:
a. Column 1, Quantity. This column shall contain the quantity of each unit and accessories
supplied with the equipment.
b. Column 2, Item name or nomenclature. This column shall contain the official name (for
example, pump, winch) or nomenclature (name and designation) of each component, unit or
accessory.
c. Column 3, PIN number, RIC number, or unit number. This column shall contain the PIN,
RIC, or unit number of each equipment unit or accessory.
d. Column 4, Overall dimensions. This column shall contain the crated (if available) and
uncrated height, width, and depth in inches (or inches and centimeters) of each unit or
accessory.
e. Column 5, Weight and volume. This column shall contain the crated (if available) and
uncrated weight and volume in cubic feet of each unit and accessory.
3.6.2.2.6 Equipment and publications required but not supplied. A tabular listing of all test
equipment and publications required but not supplied with the equipment or system shall be
included. Unless otherwise specified in the TMCR (see 6.2), NAVSEA ST000-AA-IDX-
010/PEETE shall be used as a guide for the selection and application of test equipment required
for shipboard use. If a measurement requirement is established which cannot be satisfied by the
subcategory (SCAT) codes listed in this guide, or alternate test procedures cannot be developed
utilizing the listed SCAT request for assistance should be directed to:
Commander
Naval Sea Systems Command
Arlington, VA 22242-5160
17
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business