MIL-DTL-24784 / 21B (SH)
during trouble- shooting and for a standard to be re-established after overhaul (see figure 21-39).
Each space shall be identified by the step or paragraph number which provides the instructions for
accomplishment. Each space shall contain the respective unit of measurement (for example, amp.,
dB., or V.) When applicable, waveforms shall be included to show the points on the pattern
where the measurement is to be taken. In addition, critical installation data shall be included, such
as the length of the transmission line.
4. VERIFICATION
4.1 Quality assurance provisions. The quality assurance requirements for delivery of book plans,
review draft copies, preliminary technical manuals, final reproducible copy, technical manuals,
replenishment materials, changes and revisions shall be in accordance with MIL-DTL-24784.
5. PACKAGING
5.1 Packaging requirements. For acquisition purposes, the packaging requirements shall be as
specified in the contract or order (see 6.2). When actual packaging of materiel is to be performed
by DoD personnel, these personnel need to contact the responsible packaging activity to ascertain
requisite packaging requirements. Packaging requirements are maintained by the Inventory
Control Point's packaging activity within the Military Department or Defense Agency, or within
the Military Department's System Command. Packaging data retrieval is available from the
managing Military Department's or Defense Agency's automated packaging files, CD-ROM
products, or by contacting the responsible packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but it is
not mandatory.)
6.1 Intended use. The technical manuals prepared to this specification are intended to be used
for installation, operation, maintenance, repair, and parts support of digital equipment. The
technical manual will be used as a training document in the classroom and as a source for on-the-
job training.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a. Title, number, and date of the specification (or any TMCR referencing this specification).
b. Scope of coverage if other than specified (see 1.1.1)
c. Issue of DoDISS to be cited in the solicitation, and if required, the specific issue of individual
documents referenced (see 2.2.1 and 2.3).
d. Deliverable products and data items (see 3.3).)
e. Arrangement if other than the standardized format (see 3.4).
f. Format and preparation instructions if other than as specified in MIL-DTL-24784 (see 3.5)
g. Illustrations, drawings, diagrams and sketches if other than as specified in the
MIL-DTL-24784 (see 3.5.1).
39
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business