MIL-PRF-63010C
2.2.2 Other Government documents, drawings, and publications. The following other Government
documents, drawings, and publications form a part of this document to the extent specified herein. Unless
otherwise specified, the issues are those cited in the solicitation (see 6.2).
DOD Directive 5230.24 --
Distribution Statement on Technical Documents
(Copies of DOD Directive 5230.24 can be obtained from the Standardization Documents Order Desk,
700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
2.3 Non-Government publications. The following document(s) form a part of this document to the
extent specified herein. Unless otherwise specified, the issues of the documents which are DOD adopted
are those listed in the issue of the DODISS cited in the solicitation. Unless otherwise specified, the issues
of the documents not listed in the DODISS are the issues of the documents cited in the solicitation (see
6.2).
AMERICAN SOCIETY OF MECHANICAL ENGINEERS
ASME Y14.100M
Engineering Drawing Practices
(Application for copies should be addresses to the American Society of Mechanical Engineers, 3 PArk
Avenue, M/S 10D, New York, NY 10016.)
2.4 Order of precedence. In the event of a conflict between the text of this specification and the
references cited herein, the text of this specification shall take precedence. Nothing in this document,
however, shall supersede applicable law and regulations unless a specific exemption is obtained.
3. REQUIREMENTS
3.1 General. Unless otherwise specified, DOD Standard Generator Set technical manuals prepared
in accordance with this specification shall meet all applicable requirements herein.
3.1.1 Style and format. Unless otherwise specified, style and format shall be in accordance with
MIL-STD-38784.
3.1.2 Page/paragraph numbering. Pages and paragraphs shall be numbered in accordance with
MIL-STD-38784.
3.1.3 Illustrations. Unless otherwise specified, all illustrations shall be line drawings in accordance
with MIL-STD-38784. Illustrations shall support procedures or other text and shall be of sufficient detail
to depict all essential data needed by intended user.
3.1.3.1 Engineering drawings. When engineering drawings (prepared in accordance with ASME
Y14.100M) are used, they shall be simplified or modified to portray only those details essential to serve
the intent of the illustration.
3.1.3.2 Callouts. Unless otherwise specified, numerical callouts on illustrations shall be arranged
clockwise in numerical sequence beginning at approximately 11 o'clock. Callouts shall be identified by
item name on legends. They shall be called out in the associated text.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business