MIL-DTL-24784/12B(SH)
be supplied to the extent that it is required to understand the operation of the equipment, concept
of troubleshooting, and to serve the basis for affecting a critical repair.
3.6.6.6 Flow charts. Flow charts for digital devices shall be provided to support the explanation
of machine instructions and test programs, and shall be in accordance with ISO 6829.
3.6.6.7 Coding instruction sheets. Coding instruction sheets shall be provided for all programs.
The listing shall contain all coding and address data as well as an adequate notes section to ensure
understanding (see figure 12-7).
3.6.6.7.1 Test programs. Test programs with coding instruction sheets shall be developed and
included to support troubleshooting procedures.
3.6.6.8 Troubleshooting dependency diagrams. One of the following types of troubleshooting
diagrams shall be provided to augment the troubleshooting procedures. Supporting information
required to explain the use of the diagrams shall be provided in the test or general notes.
a. Fault logic diagrams (see MIL-DTL-24784).
b. Troubleshooting-maintenance dependency-matrix chart (see MIL-DTL-24784).
3.6.7 Chapter 6, Corrective maintenance. This chapter shall contain instructions required to
adjust and align the equipment, remove, clean, inspect, repair, reinstall, and align all repairable
parts, modules, subassemblies, and assemblies. The instructions shall identify the action to be
accomplished; safety precautions to be observed; tools, parts, materials, and test equipment
required; preliminary control settings; test equipment setup instructions; and step-by-step
instructions, with supporting illustrations, to accomplish the maintenance task. Corrective
maintenance instructions shall be provided for all items designated repairable irrespective of the
maintenance concept unless this information is included in another technical manual and can be
referenced.
3.6.7.1 Introduction. The introduction shall contain an explanation of the purpose, scope, and
arrangement of the corrective maintenance data.
3.6.7.2 Section I, Adjustments and alignment. This section shall contain all information and
procedures required to perform all necessary adjustments and alignments as follows:
a.
Nonoperator type adjustments.
b.
Alignments requiring external jigs, test equipment, or bench setups.
c.
Alignments that are accomplished after a repair or replacement of a part or module.
d.
Test equipment setup and other illustrations necessary to support the procedures.
3.6.7.3 Section II, Repair. The repair section shall contain all procedures required in the repair
of assemblies and repairable parts. Repair procedures shall include but not be limited to the
following:
15
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business