MIL-DTL-24784/7C(NAVY)
3.8.1.6 Deviations and waivers. A statement shall be provided that waivers and deviations for minor material
or performance characteristics may be approved at the local level only with Government approval. Major design or
logistic deviation and waiver request will be approved in writing by the Government. Parts, clearances, or
conditions for which specified requirements cannot be met require compliance with MIL-HDBK-61, execution of
Form 1694 for deviations and waivers, and approval for a departure from specification.
3.8.2 Chapter 2 - facilities, test equipment, personnel, and test conditions. This chapter shall state the
requirements for the facilities, equipments, and overhaul personnel required to accomplish effective, efficient
refurbishment of the items covered by the TRS. This section shall consist of the following information.
3.8.2.1 Facilities. The facilities required (specify quantities) for the repair process shall be identified and
described. The following information shall be normally listed in a tabular form:
a.
Work area, space, and storage requirements.
b.
Shop machine, handling, and support equipment requirements (common and special).
c.
Electrical power and ground requirements.
d.
Hazard or safety and security requirements.
e.
Electromagnetic interference and compatibility requirements.
f.
Forced ventilation or air changes required from the facility.
g.
Service requirements; for example, water, gas, hydraulic oil, and so forth (specify required pressures and
flow rates).
h.
Other facility requirements as determined.
3.8.2.2 Test equipment. A tabular listing shall be developed and shall describe all test equipment and repair
aids required (specify quantities) in the examination, repair (including alignment, adjustment, and troubleshooting),
and performance or acceptance testing of the repairable items covered by the TRS. These data shall be provided in
the form shown on figure 5.
a.
General-purpose electronic test equipment (GPETE) shall be selected from standard or substitute standard
GPETE as listed in MIL-PRF-28800. (When it is determined that there is no standard or substitute standard
GPETE suitable for performing the required tests, the situation shall be described, justified, and referred to
the Government. Written authorization shall be obtained prior to the selection of nonstandard test
equipment.).
b.
Equipment that is no longer manufactured or available to the Government shall not be listed.
c.
The accuracy of the recommended test equipment shall be less than 25 percent of the tolerance allowed for
the measured parameter.
d.
Common hand tools normally used at depot maintenance facilities, for example, screwdrivers, wrenches,
and pliers, shall not be listed in the tabular format.
e.
Unique or special maintenance and calibration requirements of the equipment listed in this section of the
TRS shall be specified. If no unique or special maintenance and calibration is required of any listed
equipment, the TRS shall so specify.
3.8.2.2.1 Test equipment list. The following types of equipment shall be listed:
a.
GPETE.
b.
Special purpose electronic test equipment.
c.
Automatic test equipment, and its peripheral equipment and software.
d.
Dynamic test equipment; for example, rate tables, tilt tables, centrifuges, vacuums, and atmospheric
pressure equipment.
e.
Weapon system or equipment product hardware (when prescribed as a test bed for repairable items testing).
f.
Special test equipment or test set-up accessories; for example, adapters, extender cards, and connecting
cables required to interface with the repairable items.
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business