MIL-PRF-63017D(TM)
"REPORTING ERRORS AND RECOMMENDING IMPROVEMENTS
You can help improve this manual. If you find any mistakes, or if you know of a way to
improve this publication, please let us know. Mail your letter or DA Form 2028
(Recommended Changes to Publications and Blank Forms) located in the back of this
manual directly to: (the address of proponent). You may also send in your recommended
changes via electronic mail or by fax. Our e-mail address is (insert e-mail address of
proponent). Our fax number is (insert fax number of proponent). A reply will be furnished
to you."
3.2.1.6 Table of contents. The table of contents shall be prepared in accordance with MIL-STD-38784.
When space permits, the table of contents shall begin below the Reporting Errors and Recommending
Improvements statement. If space does not permit, it shall begin on the next page.
3.2.1.7 Introduction. If the introduction is included in the front matter, it shall be placed on the first page
after the table of contents. If the table of contents ends on a left-facing page, the reverse right-facing page
shall be blank and the introduction paragraph shall begin on the next left-facing page. A statement similar to
the following shall be included in the introduction:
"This manual is a reference document published as an aid in training, familiarization, and identification of
(insert commodity item). This manual is not authorization for requisitioning, stockage, maintenance, or issue
of the material described herein."
3.2.2 Data sheets. Information on data sheets (see 6.4.2) shall contain, as applicable, the following
information. NOTE: "a" is applicable to ammunition data sheets only; "e" is applicable to munitions
equipment data sheets only; no code is applicable to both (see figures 5 and 6). Ammunition data sheets
shall be separated into chapters based on commodity and each data sheet chapter shall have a title page.
a. Photograph or line drawing of the munitions equipment or ammunition item
b. Type classification (a).
c. Use
d. Description
e. Functioning
f. Differences between models
g. Tabulated data
h. Performance (a)
i. Temperature limits (a)
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business