MIL-DTL-23618H(AS)
assist time required, for example, "Assisted by AMS No. 2 (0.3 hrs)." When a task
requires the use of multiple assistants whose responsibilities are of an unskilled nature
and not well defined, the prime card shall state, "assistance as required."
(2) A list identifying the noun nomenclature and part, type, or specification number of
special tools and SE required to accomplish all tasks shall precede the consumable/
replacement parts list or in the absence of the consumable/replacement parts list, shall
precede the first task of the prime card. However, special tools with several alternate
part numbers which are easily identified by noun nomenclature do not require further
identification by part number, i.e., oil cans, grease guns, torque wrenches, etc.
Common hand tools (tools commonly found in the maintenance worker's toolbox) are
not included in this list. If only one special tool or item of SE of a particular type is
listed, then only its noun nomenclature shall appear in the task or step requiring it. An
exception to this requirement is allowed in the QECA manual when due to the close
similarity of certain items, such as spanner wrenches and bearing pullers, there is a
distinct possibility that the wrong tool could be selected. When more than one special
tool or item of SE with the same noun nomenclature is listed, each item shall be
identified by part, type, or specification number in the tasks or steps to which they
apply.
(3) A list of consumables and replacement parts necessary to accomplish the task shall
precede the first task of the prime card. When more than one consumable or
replacement part with the same noun nomenclature is listed, the part, type, or
specification number shall be specified in each applicable task or step. If, however,
only one consumable or replacement part of a particular nomenclature is listed, then
only the nomenclature shall be identified in the applicable task or step. An exception
to this requirement is allowed in the QECA manual when due to the close similarity of
certain consumables and replacement parts, there is a distinct possibility that the wrong
item could be selected and installed if not fully identified.
(4) Each task and its related steps shall be arranged in a logical sequence to provide a
means of performing the requirements in the most accurate and efficient manner. Task
cards may be grouped alphabetically by rating or numerically by MOS when more than
one rating or MOS is applicable.
(5) When two or more assemblies have identical task requirements, only the first
assembly's task need by fully identified. Subsequent assemblies requirements shall
state, "repeat task (number) through task (number)."
(6) Requirements appearing on each primary card and its associated decimal card(s) shall
be limited to a single system, subsystem, assembly, or component. If, however, the
requirements to be listed are not extensive enough to warrant individual primary cards,
75
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business