MIL-DTL-5096G
Electronic Presentation: Work cards shall only be enumerated on new card elements.
3.6.4.1.1 Phased inspection card number. Each card shall be assigned a sequential number which shall
appear on the front and back of the card. When speciied by the acquiring activity (see 6.2x.), card numbers
shall be preixed according to their groupings or applicable phase (e.g. irst phase, second phase, etc.).
Electronic Presentation: Data shall be formatted as a scrolling table.
3.6.4.2 Work area(s). These blocks shall list the work area or areas in which the tasks listed on the card shall
be performed. The work area numbers shall be obtained from the work area diagram. When more than one
work area is involved, the work area numbers shall be listed in the order in which the areas will be occupied.
3.6.4.3 Type mechanic required. This entry shall identify the type mechanic or specialist (e.g., AIRCRAFT,
ENGINE, HYDRAULIC, etc.) required to accomplish the tasks listed on the card. Where assistance is
required by a type mechanic other than that listed, an "Assisted by mechanic type" note shall be
added to the beginning of the task.
3.6.4.4 Mechanic number required. This entry shall identify the recommended quantity of specialists
required to accomplish the tasks outlined on the work card.
3.6.4.5 Card time. This entry shall indicate the amount of time needed to accomplish the tasks prescribed
by the card. This shall be the total time required for all items relected in the body of the card. Time
shall be indicated in hours and minutes; i.e., 02:15, 01:40, 00:25, etc. All time shall be relected to
the nearest minute and relected in four digits.
3.6.4.6 Technical manual identiication and change numbers. The technical manual identiication number
and change number shall be placed in the respective blocks. Neither the publication nor change
dates shall be given.
3.6.4.7 Body heading (inspection requirements). An entry shall be made in this block to indicate the
type of inspection for which the card set applies. For example: Prelight, Basic Postlight, Periodic,
100 hour, 200 hour, 180 days, etc.
3.6.4.8 Electrical power.
a. When power is required during the accomplishment of the tasks entered on the card, the
word "ON" shall be placed in this block.
b. When it is mandatory that power be off during the accomplishment of the tasks entered on the
card, the word "OFF" shall be placed in this block.
c. When power may be on or off during the accomplishment of the tasks entered on the card, this
block shall be left blank.
d. Power on and off requirements shall normally not be stated on the same card except when
necessary for continuity of the operation, in which case, the word "ON/OFF" shall be placed
in this block and each power ON requirement shall be preceded by an "at" (@) symbol
in the body of the card.
3.6.4.9 Service. When speciied by the acquiring activity, this block shall be completed (see 6.2y.),
otherwise it shall be left blank. When service must be interrupted to accomplish the tasks on the card, the
word "OUT" shall be placed in this block. When service need not be interrupted to accomplish the tasks on
the card, the word "IN" shall be placed in this block. When there are both in and out of service conditions
relating to the tasks on the card, the words "IN/OUT" shall be placed in this block.
3.6.4.10 Figure. Unless otherwise speciied by the acquiring activity (see 6.2z.), this block shall be left
blank. When speciied by the acquiring activity, igure numbers or other identiier shall be assigned to the
igures on each card and this shall be inserted in the igure block.
3.6.4.11 Man-minutes column. The man-minutes required to accomplish each individual inspection item
shall be entered in this column. If work cards contain a series of short time items, a horizontal dash may
be placed on the line for the irst and last items of the group and the time may be made as a single
entry midway between the two horizontal dashes.
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business