MIL-DTL-85383A(AS)
d. Aircraft surface critical contour tolerances.
e. Reaming and bushing tolerances.
f. Allowable clearances.
3.2.7.7 Common shop practices. Common shop practices peculiar to the aircraft shall be
included when not covered in general series manuals. The following types of information are
included in this category:
a. Sheet metal forming.
b. Working titanium alloys.
c. Substitution, removal, and installation of fasteners equal to or better than original
equipment.
d. Filling dimpled and countersunk holes.
e. Coin dimpling (including special tools required).
f. Repairing welds.
g. Substituting parts.
h. Local manufacturing of parts.
i. Working high strength steel.
j. Working composite materials.
3.2.7.8 Repairs contained in general repair manuals. When repairs contained in general series
manuals are acceptable for use, those procedures shall be referenced as specified in
MIL-DTL-81927 (see 3.1.4).
3.2.7.9 Crash handling and shipping. The following types of data shall be included to cover
handling and shipping of crash damaged aircraft:
a. Procedures and safety precautions for handling hazardous items such as batteries, fuel, oil,
liquid oxygen, and explosive devices. The requirements of CFR 49, OSHA regulations,
and general series manuals shall be complied with.
b. Procedures for lifting the aircraft. This shall include identification of necessary handling
equipment .
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business