MIL-DTL-85383A(AS)
d. Precautions to be observed while working with sealing materials.
3.2.10.4.1.2 Fuel tank sealing. Fuel tank sealing shall be covered in a separate WP(s).
3.2.10.4.2 Pressure testing. Information and procedures shall be included for pressure testing
of sealed compartments when such testing is required to check for leakage or structural integrity
after repair.
3.2.10.4.3 Control surface balancing. Information and procedures shall be prepared for mass
balancing and dynamic balancing of those hinged control surfaces which have balancing provisions
included in their design. Mass balancing shall be covered using calculated methods and using
improvised methods with allowable field tolerances.
3.2.10.4.4 Removal and installation instructions. Procedures shall be included for removal and
installation of all repairable structure that is not covered in the organizational level aircraft
maintenance manual.
3.2.10.4.5 Local manufacturing or assembling. Information and procedures for local
manufacture or assembly shall be included for items source coded for local manufacture or
assembly when this data is not available from other manuals. In addition, information and
procedures shall be included for manufacturing required items such as jigs, templates, supporting
fixtures, and unique packing crates when these are not otherwise covered. Manufacturing
procedures shall include dimensions and material requirements.
3.3 Corrosion control detail requirements. Corrosion control data shall contain information
and procedures required to inhibit the onset of corrosion, to determine the location and extent of
corrosion damage, to remove corrosion, and to apply necessary treatment to prevent further
corrosion damage. When structure or components have been damaged by corrosion, applicable
structure repair procedures shall be referenced to repair the damage.
3.3.1 Corrosion control introduction WP. An introduction WP shall be prepared as specified
in MIL-DTL-81927 (see 3.1.4). In addition to the requirements of MIL-DTL-81927, the
following shall be included as applicable:
a. Pertinent information on how to use the manual or volume.
b. An explanation of applicability notations used in the manual or volume.
3.3.2 Corrosion control - general information.
3.3.2.1 Corrosion control materials requirements. A separate WP containing lists of all
materials required to complete the procedures detailed in the manual shall be prepared. The
following shall be shown as applicable for each item listed:
17
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business