MIL-DTL-24784/14B(SH)
3
RESISTOR, FIXED, COMPOSITION: 3000 ohms + 5%
1/2w; mfr 42384 dwg 4469D69
4
RESISTOR, FIXED, COMPOSITION: 4000 ohms + 5%
1/2w; MIL type RC20GF402J.
3.6.3.7.5 List of attaching hardware. A list shall be included that shows items of attaching
hardware. Attaching hardware shall be listed alphanumerically and identified by an assigned
letter. For example:
Letter code
Name and description
A
CAPSCREW, 1/4-28, UNF-2A, 1 in. lg, HEX HEAD,
DRILLED HEAD, CRES MS51100-8.
B
WASHER, FLAT, 0.750 in. ID, 0.312 in. OD, 0.066 in.
thickness, STEEL, ROUND.
Items used fewer than five times need not be included in the list of attaching hardware providing
the item is completely identified in the parts list, following the part identification that is being
attached.
3.6.3.7.6 List of manufacturers. The list of manufacturers shall contain the names, addresses,
and CAGE number of all manufacturers supplying items for the equipment as referenced in the
parts list. The list shall be presented in numerical sequence by CAGE number. CAGE numbers
shall be in accordance with Cataloging Handbook H4/H8.
3.6.3.7.7 Parts location illustrations. Illustrations shall be included to provide positive and rapid
location of parts. Types of parts location illustrations include exploded views, when approved by
the Government, engineering drawings and sectional views, printed-circuit boards, as applicable
(see MIL-DTL-24784). Suitable parts location illustrations located in other chapters of the
manual may be referenced.
3.6.3.7.7.1 Criteria for illustrations. Items shall be called out on illustrations by call-out leader,
index number, or grid coordinates. Standard attaching hardware items (such as nuts, bolts,
washers, screws) need not be called out or illustrated, except when they are on exploded views or
are referenced in a procedure. Multiple items of attaching hardware connecting parts together
need not show every item; for example, if four screws and washers attach one part to another,
only one screw and washer need be shown, but all four screw holes on the part must be shown.
Exploded views shall be supplied for units, subassemblies, and components designated Navy
repairable but may be included in Chapter 6, "Repair and replacement", for parts-location
purposes.
3.6.3.8 Chapter 8, Installation. Drawings and information concerning installation shall be
provided in this chapter. The following type of information shall be included: site selection, or
installation location guide lines (such as moisture precautions and maximum temperature allowed
as appropriate), special tools and materials requirements, unpacking, and handling (if unusual
20
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business