MIL-DTL-83495C (USAF)
3.4.3.2.1.1.3 Personnel recommended. The minimum number of personnel required to effectively perform
the maintenance shall be provided. Location and duties for multi-person requirements shall be identiied at
the beginning of the function. When a team is required, members of the team shall be identiied at
the beginning of the procedure. For example:
Personnel Recommended: Four
Technician A: Supervise operations
Technician B: Connect and disconnect equipment
Technician C: Operate equipment
Technician D: Inspector
3.4.3.2.1.1.3.1 Multi-person requirements. Multi-person requirements shall be included as identiied in
the supportability analysis. Assistants shall be identiied when required (see 6.4.16). The responsible
technician shall be associated with the applicable action or observation. Steps shall be presented in the
sequence to be performed. A notation shall precede each step indicating which member of the team
will perform the step. For example:
(A) Position....
(B) Insert....
(B and C) Raise and install....
(D) Inspect clearance....
(A) Turn power switch to....
3.4.3.2.1.1.4 Support equipment. The government approved support equipment (test equipment, special
tools, and ground handling equipment) shall be identiied. Common types of tools normally found in the
technician s tool kit shall not be listed. Common types of test equipment such as, voltmeters, signal
generators, etc., shall be listed. Equipment shall be listed by nomenclature and Joint Type Electronics
Designation System (JTEDS), assigned Aeronautical Equipment Identiication Designators (AN/AEID), or the
commercial or manufacturers designation if the JTEDS or AN/AEID types are not assigned. Quantity
required shall be shown. When applicable, equipment capacity, range, etc., shall also be included. If
alternate equipment can be used, the term "or equivalent" shall follow the nomenclature.
3.4.3.2.1.1.5 Consumables. Consumable and expendable items required to perform all the tasks within
that function shall be listed in accordance with 3.3.5.3.2.2. see ig
3.4.3.2.1.1.6 Safety conditions. Pertinent safety information shall be included as prescribed in MIL-STD-
38784.
3.4.3.2.1.1.7 Checklist requirements (Optional). One of the following requirements shall be used when the
function is designated a checklist, as speciied by the acquiring activity: (see 6.2q.)
a. A lead-in-statement shall be provided to indicate that the function shall be followed in exact
step-by-step checklist sequence to prevent damage to equipment or injury to personnel.
b. The primary procedural steps shall be prepared in bold face type. Within a secondary procedural
step, bold face type may be used on portions with checklist value. A lead-in statement shall be
provided in the manual proceeding the function/task explaining the use of bold face type.
3.4.3.2.1.1.8 Additional data. All other technical data required to reference in the functions shall be
listed under this heading. The information required by 3.4.3.2.1.1.2 (Required Conditions) shall not be
combined with additional data.
15
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business