fire munitions and weapons that are approved for loading on an aircraft. This specification provides for electronic delivery of data through the use of the Document Type Definitions \(DTD\) contained in Appendixes A through K \(see 6.2\).

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18

MIL-DTL-9977L(USAF)

3.11.2.2.3 Emergency procedures. This paragraph(s) shall contain emergency procedures related to

munitions-loaded aircraft (see 6.7). See igure 10.

3.11.2.2.4 Aircraft general arrangement. This paragraph(s) shall contain the aircraft general arrangement in

an illustrated form, showing the location of panels and switches used by the load crew. See igure 4.

3.11.2.3 Aircraft preparation. This paragraph shall include steps which must be accomplished for munitions

loading. The steps shall contain procedures for preparation of the aircraft and installed accessories for

loading, and a stray voltage check for those munitions/accessories as required. As a minimum, power shall

be applied to the aircraft during stray voltage checks, unless otherwise speciied by the acquiring activity, in

coordination with the responsible engineering organization see 6.2. A coniguration chart, depicting authorized

loading coniguration(s) for the speciic munition, shall be shown. The steps shall include procedures to

safe any munitions items which might be on the aircraft prior to stray voltage checks (i.e., safe missile

motors, disconnect AGM-65 igniter cable, etc.).

3.11.3 Checklist (CL-2 and subsequent) arrangement. The general requirements of MIL-PRF-5096 shall apply.

print presentation only: The arrangement shall be head to foot. The contractor shall use the DTD in Appendix

J if electronic delivery of this checklist is required (see 6.2). The checklist shall contain the following:

a. Front matter.

b. General procedures.

c. Loading procedures.

d. Unloading procedures.

3.11.3.1 Front matter. The front matter shall be in accordance with the requirements of MIL-PRF- 5096.

3.11.3.2 General procedures.

3.11.3.2.1 SE. SE shall be in accordance with 3.11.2.2.1.

3.11.3.2.2 Speciic safety requirements. This paragraph shall contain all speciic safety requirements

pertaining to the munitions loading procedures of the speciic munition.

3.11.3.3 Loading procedures. Under this chapter, the following paragraphs/tasks shall be covered.

3.11.3.3.1 Munitions preparation. This paragraph is applicable to a single munition and preloaded

accessories; it shall include steps required to inspect and prepare each munition (including components). This

procedure shall include steps required to assemble and install authorized fuzes prior to munitions loading.

Procedures shall be included to verify the safety of each fuzed munition. All steps shall be singular.

3.11.3.3.2 Cartridge installation. All accessories that require preinstalled cartridges shall be included. This

paragraph shall include steps required to check impulse cartridges for serviceability, and to properly

install cartridges in those accessories that must have cartridges installed prior to loading munitions. All

steps shall be plural.

3.11.3.3.3 Loading. This procedure shall include steps required to load stores. All steps shall be singular.

This procedure shall include steps to remove fuzed safety devices after store is loaded.

3.11.3.3.4 Cartridge installation. This paragraph shall include steps required to check impulse cartridges for

serviceability, and properly install cartridges in all accessories, as required. All steps shall be plural.

3.11.3.3.5 Postloading inspection. This paragraph shall include steps required to ensure that accessory safety

devices are installed, bombs and fuzes are installed properly, and fuze safety devices have been removed or

installed, as required. All steps shall be plural.

3.11.3.3.6 Immediately prior to launch. This paragraph shall include steps required to place the aircraft in a

launch coniguration. Steps shall be included to arm munition items safed during preparation (e.g., arm

missile motors, connect AGM-65 igniter cable, etc.). All steps shall be plural.

3.11.3.4 Unloading procedures. Under this chapter, the following paragraphs/tasks shall be covered.

3.11.3.4.1 Saing. This paragraph shall include essential steps required to safe the aircraft/munitions, and

install associated safety devices. All steps shall be plural.